Jeep Wrangler 1997 Manual - page 1018
(19) Compress spring and install E-clip in groove
on shuttle valve stem (Fig. 54).
(20) Place shuttle valve end plate in position on
valve body (Fig. 55).
(21) Install screws to attach shuttle valve end
plate to valve body (Fig. 55).
(22) Install rear clutch servo and rear servo check
balls in proper cavities in transfer plate (Fig. 56).
(23) Insert filter into opening in separator plate
(Fig. 57).
(24) Place separator plate in position on transfer
plate and install screws to attach separator plate to
transfer plate (Fig. 57).
(25) Place one 11/32 in. check ball and six 1/4 in.
check balls in the proper cavities in the valve body
(Fig. 58).
(26) Place transfer plate in position on valve body
(Fig. 59).
(27) Install screws to attach transfer plate to valve
body (Fig. 59).
(28) Turn valve body over to expose the separator
plate.
(29) Insert converter clutch valve and spring into
converter clutch valve module (Fig. 60). Verify valve
components slide freely.
(30) Insert spring and fail-safe valve into converter
clutch valve module (Fig. 60). Verify valve compo-
nents slide freely.
(31) Place cover plate in position on converter
clutch valve module (Fig. 60).
(32) Install screws to attach cover to converter
clutch valve module (Fig. 60).
(33) Insert connecting tube into converter clutch
valve module (Fig. 60).
(34) Insert connecting tube into valve body open-
ing (Fig. 61).
(35) Place converter clutch valve module in posi-
tion on separator plate. Install screws to attach con-
verter clutch module to valve body (Fig. 61).
(36) If necessary, install a new O-ring on converter
clutch solenoid (Fig. 62).
Fig. 54 Shuttle Valve E-Clip And Secondary Spring
Fig. 55 Shuttle Valve End Plate
Fig. 56 Rear Servo and Rear Clutch Check Balls
Fig. 57 Transfer And Separator Plates
21 - 112
TRANSMISSION AND TRANSFER CASE
TJ
DISASSEMBLY AND ASSEMBLY (Continued)