Jeep Wrangler 1997 Manual - page 1016
(19) Remove screws attaching separator plate to
transfer plate (Fig. 49).
(20) Note position of filter, rear clutch servo and
rear servo check balls for assembly reference (Fig.
49) and (Fig. 50).
(21) Remove shuttle valve end plate (Fig. 51).
(22) Remove shuttle valve E-clip and remove sec-
ondary spring and spring guides from end of valve
(Fig. 52).
(23) Remove governor plug end plate (Fig. 53).
(24) Remove 1-2 and 2-3 shift valve governor plugs
from valve body (Fig. 53).
(25) Remove shuttle valve throttle plug, primary
spring and shuttle valve from valve body (Fig. 53).
(26) Remove
screws
attaching
kickdown
limit
valve body to valve body (Fig. 53).
(27) Remove 1-2 shift control valve and spring
from valve body (Fig. 53).
(28) Remove 2-3 shift valve and spring from valve
body (Fig. 53).
(29) Remove 1-2 shift valve and spring from valve
body (Fig. 53).
(30) Remove throttle pressure plug from kickdown
limit valve body (Fig. 53).
(31) Remove retainer from end of kickdown limit
valve body (Fig. 53).
(32) Remove kickdown limit valve and spring from
kickdown limit valve body (Fig. 53).
(33) Remove regulator valve end plate from valve
body (Fig. 53).
(34) Remove regulator valve line pressure plug,
pressure plug sleeve, regulator valve throttle pres-
sure plug and spring (Fig. 53).
ASSEMBLY
Clean and inspect all valve body components for
damage or wear. Refer to the Cleaning and Inspec-
tion section of this group for proper procedure.
Fig. 49 Transfer And Separator Plates
Fig. 50 Rear Servo and Rear Clutch Check Balls
Fig. 51 Shuttle Valve End Plate
Fig. 52 Shuttle Valve E-Clip And Secondary Spring
21 - 110
TRANSMISSION AND TRANSFER CASE
TJ
DISASSEMBLY AND ASSEMBLY (Continued)