Jeep Wrangler 1997 Manual - page 871
INSTALLATION
(1) Position the latch in the door.
(2) Connect the inside handle to latch rod.
(3) Install the screws attaching the latch to the
door.
(4) Position the door weatherstrip in place, apply
adhesive as necessary.
(5) Connect the outside handle to latch rod.
(6) Connect the lock knob to latch rod.
(7) Connect the lock cylinder to latch rod.
(8) Install trim panel.
FULL DOOR LATCH STRIKER
REMOVAL
(1) Remove the screws attaching the striker to the
body.
(2) Separate the striker and the spacer from the
body (Fig. 26).
INSTALLATION
(1) Position the striker and the spacer on the body.
(2) Install the screws attaching the striker and
spacer to the body.
FULL DOOR INSIDE HANDLE ACTUATOR
REMOVAL
(1) Remove the torx screw attaching the inside
handle to the door.
(2) Carefully pull the handle from the door.
(3) Disconnect the latch rods from the handle (Fig.
27).
INSTALLATION
INSTALLATION
(1) Connect the latch rods to the handle.
(2) Position handle and seal in door.
(3) Install the torx screw attaching the inside han-
dle the to door.
Fig. 25 Full Door Latch
Fig. 26 Latch Striker
Fig. 27 Inside Handle Actuator
TJ
BODY
23 - 25
REMOVAL AND INSTALLATION (Continued)