Jeep Wrangler 1997 Manual - page 1025
REAR BAND—30RH
(31) Remove rear band. The 30RH transmission is
equipped with a single-wrap band with a link bar.
(a) Using snap-ring plier, pull rear band anchor
pin (located on the servo side of the rear support)
from transmission case.
(b) Remove rear band and link from transmis-
sion (Fig. 85).
(c) Separate rear band from link (Fig. 86).
(32) If necessary remove front and rear band servo
levers. All transmission components can be serviced
without removing the levers.
(a) Using a 1/4 inch drive extension remove
front band reaction pin access plug (Fig. 87).
(b) Remove front band reaction pin with pencil
magnet. Pin is accessible from converter housing
side of case (Fig. 88).
(c) Remove front band lever (Fig. 89).
Fig. 85 Rear Band and Link—30RH
Fig. 86 Rear Band and Link—30RH
Fig. 87 Front Band Reaction Pin Access Plug
Fig. 88 Front Band Reaction Pin
Fig. 89 Front Band Lever
TJ
TRANSMISSION AND TRANSFER CASE
21 - 119
DISASSEMBLY AND ASSEMBLY (Continued)