Jeep Wrangler 1997 Manual - page 933
(3) Remove the output shaft pilot bearing rollers
from the input shaft and the output shaft.
(4) Remove the fourth gear synchronizer ring from
the input shaft (Fig. 98).
(5) Remove the select fit snap-ring holding the
input shaft bearing onto the input shaft.
(6) Using Bearing Splitter P-334 and a shop press,
remove the bearing from the input shaft.
ASSEMBLY
(1) Position input shaft bearing onto input shaft.
(2) Using Driver L-4507, drive bearing onto input
shaft.
(3) Select the thickest snap-ring that will fit into
the snap-ring groove of the input shaft (Fig. 99).
(4) Lubricate output shaft pilot bearing bore of
input shaft with petroleum jelly.
Fig. 98 Input Shaft Components
Fig. 99 Select Input Shaft Bearing Snap-ring
TJ
TRANSMISSION AND TRANSFER CASE
21 - 27
DISASSEMBLY AND ASSEMBLY (Continued)