Jeep Wrangler 1997 Manual - page 1092
OIL PUMP AND REAR CASE ASSEMBLY/INSTALLATION
(1) Install magnet in front case pocket (Fig. 70).
(2) Assemble oil pickup screen, connecting hose,
and tube.
(3) Install new pickup tube O-ring in oil pump
(Fig. 71).
(4) Insert oil pickup tube in oil pump inlet.
(5) Position assembled oil pump and pickup tube
in rear case. Be sure pickup screen is securely seated
in case slot. Also be sure oil pump locating tabs are
outside rear case (Fig. 72).
(6) Apply 3 mm (1/8 in.) wide bead of Mopar
t
gas-
ket maker or silicone adhesive sealer to mounting
flange of front case. Work sealer bead around bolt
holes.
(7) Lift rear case and oil pump and carefully posi-
tion assembly on front case. Be sure case dowels are
Fig. 68 Installing Drive Chain And Front Output
Shaft
Fig. 69 Install Mode Fork Spring
Fig. 70 Installing Case Magnet
Fig. 71 Pickup Tube O-Ring Position
Fig. 72 Oil Pump And Pickup Tube Installation
21 - 186
TRANSMISSION AND TRANSFER CASE
TJ
DISASSEMBLY AND ASSEMBLY (Continued)