Jeep Wrangler 1997 Manual - page 872
FULL DOOR GLASS
REMOVAL
(1) Remove the door trim panel and the waterdam.
(2) Pull the door glass run channel from the door
sail.
(3) Roll glass fully downward.
(4) Remove the door sail panel (Fig. 28) and (Fig.
29).
(5) Roll glass 1/4 upward to access regulator arm
guide.
(6) Remove the screws that attach the regulator
arm guide to the glass.
(7) Lift the glass upward while tilting inward and
remove from the door.
INSTALLATION
(1) Position the glass in the door ensuring the
glass is aligned in the glass run channel.
(2) Install the screws that attach the regulator
arm guide to the glass.
(3) Install the door sail panel.
(4) Install the run channel in the door sail.
(5) Install the waterdam and the door trim panel.
FULL DOOR INNER BELT WEATHERSTRIP
The inner belt weatherstrip is attached to the door
trim panel and is not serviceable. If the inner belt
weatherstrip needs to be replaced, replace the door
trim panel.
FULL DOOR OUTER BELT SEAL
REMOVAL
(1) Remove the door sail panel.
(2) Disengage the clips attaching the outer belt
seal to the door (Fig. 30).
(3) Separate the seal from the door.
INSTALLATION
(1) Position the seal on the door.
(2) Engage the clips attaching the outer belt seal
to the door.
(3) Install the door sail panel.
Fig. 28 Door Sail Screws
Fig. 29 Door Sail Removal
Fig. 30 Full Door Outer Belt Seal
23 - 26
BODY
TJ
REMOVAL AND INSTALLATION (Continued)