Jeep Wrangler 1997 Manual - page 971
COUNTERSHAFT
DISASSEMBLY
(1) Remove select fit snap-ring holding the coun-
tershaft front bearing onto the countershaft (Fig.
105).
(2) Using Bearing Splitter P-334, a suitable spacer
on center of countershaft, and a shop press, remove
the countershaft front bearing from the countershaft.
ASSEMBLY
(1) Remove any nicks or burrs on countershaft hub
with fine emery or crocus cloth.
(2) Position countershaft front bearing on end of
countershaft. Be sure the snap-ring groove in bearing
is facing forward.
(3) Using Special Tool 8109 and a shop press,
press bearing onto countershaft.
(4) Select the thickest snap-ring that will fit into
the snap-ring groove of the countershaft (Fig. 105).
(5) Install snap-ring to hold countershaft front
bearing onto countershaft.
INPUT SHAFT
DISASSEMBLY
(1) Verify that the 3–4 synchronizer is in the neu-
tral position.
(2) Separate input shaft from output shaft (Fig.
106).
Fig. 104 Install Detent Balls And Springs
Fig. 105 Countershaft Front Bearing Snap-ring
Fig. 106 Separate Input and Output Shafts
TJ
TRANSMISSION AND TRANSFER CASE
21 - 65
DISASSEMBLY AND ASSEMBLY (Continued)