Jeep Wrangler 1997 Manual - page 883
INSTALLATION
(1) Position and align the console in the vehicle.
(2) Install the bolts attaching the console to the
floor pan.
(3) Install the trim disc
(4) Install shift boot/indicator bezel.
(5) Return seats to normal position.
(6) Install the shift handle.
FULL FLOOR CONSOLE
REMOVAL
(1) Move the seats to the full rearward position.
(2) Move the passenger seat in the full recline
position.
(3) Grasp shift handle (auto trans only) and firmly
pull upward to remove.
(4) Using a small flat blade, pry up shift indicator
bezel, disengage bezel lamp connector and remove
bezel (auto trans only).
(5) Using a trim stick, pry up shift boot and
remove (manual trans only).
(6) Remove the bolts attaching the console to the
floor pan (Fig. 62).
(7) Shift transfer case to four low position.
(8) Engage parking brake.
(9) Lift the console upward and rotate to remove
through the passenger door.
INSTALLATION
(1) Position and align the console in the vehicle.
(2) Install the bolts attaching the console to the
floor pan.
(3) Install shift boot/indicator bezel.
(4) Return seats to normal position.
(5) Install the shift handle.
CONSOLE LOCK CYLINDER
REMOVAL
(1) Open the console cover.
(2) Remove the screw that attaches the retainer to
the lock and then remove the retainer from the lock
(Fig. 63).
(3) Remove the lock cylinder from the console
cover.
INSTALLATION
(1) Insert the assembled lock in the console cover
hole and position the retainer on the lock and install
the screw.
Fig. 61 Mini Floor Console
Fig. 62 Full Floor Console
Fig. 63 Console Lock Cylinder
TJ
BODY
23 - 37
REMOVAL AND INSTALLATION (Continued)