Jeep Wrangler 1997 Manual - page 1085
ASSEMBLY
Lubricate transfer case components with Mopar
t
Dexron II automatic transmission fluid or petroleum
jelly (where indicated) during assembly.
BEARING AND SEAL INSTALLATION
CAUTION: The bearing bores in various transfer
case components contain oil feed holes. Make sure
replacement bearings do not block the holes.
(1) Remove the front output shaft seal from case
with pry tool (Fig. 40).
(2) Remove the front output shaft bearing retain-
ing ring with screwdriver (Fig. 41).
(3) Remove bearing with Tool Handle C-4171 and
Tool 5065 (Fig. 42).
Fig. 37 Front Tabbed Thrust Washer Removal
Fig. 38 Input Gear Removal
Fig. 39 Rear Tabbed Thrust Washer Removal
Fig. 40 Front Output Seal Removal
Fig. 41 Front Output Shaft Bearing Retaining Ring
Removal
TJ
TRANSMISSION AND TRANSFER CASE
21 - 179
DISASSEMBLY AND ASSEMBLY (Continued)