Oce Arizona T220UV User Manual - T220Uv Lamp Bulb Replacement
T220UV Lamp Bulb Replacement |
6/2/04
6-89
6.6
T220UV Lamp Bulb Replacement
Kit Contents (Part #3012002526):
•
Cotton gloves (1 pair)
•
2 optical cleaning wipes
•
3mm Allen key
•
MSDS UV Lamp Safety Data Sheet
•
UV lamp bulb
•
Lamp replacement instructions
Tools needed:
•
Philips screwdriver,
•
Protective clear glasses.
6.6.1
Replacing the Bulb on the Blot Side of the Gantry
If the blot side lamp needs replacing, use the control panel Operator/Maintenance menu
to issue the "Access Carriage" command before turning the power off. This moves the
carriage to the blot side for easy access to the UV illuminator on that side. This is not
necessary when replacing the bulb on the carriage side.
6.6.2
Procedure for Bulb Replacement
1.
If the UV lamps are on (even if one has burned out, the other may still be on) use the
Operator/Maintenance/turn on/off uv lamp menu to turn the lamps off. Wait until
you see “Ready” displayed in the top left corner of the control panel display before
proceeding to step 2. This ensures that the UV illuminators have cooled
Note:
When replacing the lamp bulb in the illuminator at the blot cloth station, be
aware that with the power off you cannot move the carriage manually. Also,
there is no vacuum to hold the ink in the system. Eventually, the ink will start
to drip from the heads. Make sure that the carriage is parked directly over the
blot cloth so that it will absorb any drips of ink. Also, when you power the
printer on again, make sure that you advance the blot cloth manually to a
clean area of the roll if any ink has spilled on it.
This is not an issue when replacing a bulb on the carriage side since the waste
tray will collect any spilled ink.