Oce Arizona T220UV User Manual - Printing Direction
Printing a Job |
6/2/04
3-55
However, if the Print Parameters were enabled in the Operator/Print Parameters menu
by setting the feature to ON, then either some, or all of the following set of print job
options are displayed, allowing you to change them.
3.2.2
Print Job Parameter Options
The print job parameter options consist of three functions that support printing. Only if
a particular option was enabled in the Operator\Enable Job Parameters Change menu, its
associated screen is displayed in the following order.
Tip: Use the MENU key to move to the next option if no changes are required for a
particular parameter.
Printing Direction
Press + or - to change the printing direction. Options are Single or Bidirectional —
single means that the nozzles will print only in the right to left direction, while
bidirectional prints in both directions. Press ACCEPT when the printing option you
want is displayed.
Overprints
Press + or - to change the number of times the image prints on top of the first print.
Options are 1 to 3. Use the ACCEPT key to move through the displayed digits. The
selected digit has an underline indicating it can be increased or decreased using the + or
Note:
If Display Print Parameters is set to OFF in the Operator/Print Parameters/
Statistics menu, the control panel display shows the message “Place media
on the table” and the print job can begin.
Note:
Which of the Print Parameters Options are displayed, and thus able to be
changed, is determined by whether or not that particular job option was
enabled in the Operator\Enable Job Parameters Change menu.
Print Mode
speed 1x
PRINT PARAMETERS
Dir: bidir L<-->R
Print Mode
speed 1x
PRINT PARAMETERS
# Overprints: 1