Oce Arizona T220UV User Manual - Operating The Arizona T220Uv
6/2/04
3-49
3
Operating the Arizona T220UV
Before operating the Arizona T220UV printer, make sure you have read and
understood the section “Safety Information” on page 4.
Océ Operator Training
For optimal safety and print quality, the Arizona T220UV printer operator must be
trained by a qualified Océ service personnel. Océ training provides a general
orientation to the Arizona T220UV printer safety and operating procedures. This
training involves both the User Training and Maintenance Training modules.
PosterShop Training
Maximum performance from the Arizona T220UV printer requires a properly trained
operator. Océ Service and Support Group trains the operator in the use of the Arizona
T220UV hardware and software at installation. However, this is not a substitute for
formal PosterShop® training.
Operators of the Arizona T220UV should be fully versed in the operation of Onyx
PosterShop® . For any operator unfamiliar with its operation, Onyx PosterShop®
training is required. On-site or off-site training courses are available; contact Onyx
Graphics Corporation for more information:
Visit http://www.onyxgfx.com/support_training.html
3.1
Powering On and Off
Before powering On, make sure that loose objects such as clothing, tools and cleaning
materials are not interfering with the printer mechanisms. Position the power cord so
that it does not pose a hazard when walking around or accessing the doors on the
printer. The Arizona T220UV has an AC power circuit breaker switch and an On/Off
switch (it also has an AC power plug, referred to as the Disconnect Device - see below)
located on the side of the electronics enclosure.
Important: After powering the printer On, leave it running continuously even when
at idle to keep it at its optimum operating specifications. Failure to do so
may result in ink draining out of the ink reservoirs.