Oce Arizona T220UV User Manual - page 66
Océ | Operating the Arizona T220UV
3-54
3010102780-B
If you pressed + or - to change settings while the print job information was displayed,
the following screen appears.
Use the ACCEPT key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want is displayed, press ACCEPT and the underline moves to the next digit. When
you are at the last digit, pressing ACCEPT advances to the Offests menu.
Tip: Use the MENU key to move to the next option if no changes are required for a
particular field.
Changing UV Power Setting
This display lets you change the power setting of the UV lamps. If power is set too low,
the ink will not cure properly. A higher setting results in more curing of the ink but also
applies more heat to the media.
Use the ACCEPT key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want to use is displayed, press ACCEPT and the underline moves to the next digit.
When you are at the last digit, pressing ACCEPT advances to the Offests display menu.
Changing Horizontal and Vertical Offsets
This display allows you to change first the horizontal and then the vertical offsets. For a
diagram illustrating the orientation of these offests, see “T220UV Printing Direction and
Use the ACCEPT key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want to use is displayed, press ACCEPT and the underline moves to the next digit.
When you are at the last digit, pressing ACCEPT advances to the Place Media display
if Print Parameters were NOT enabled in the Operator/Print Parameters menu.
Print Mode
speed 1x
Enter new media thickness:
04.00mm
Print Mode
speed 1x
Enter UV Power: (Max: 80%)
70%
Print Mode
speed 1x
Enter new H offset: (6 to 2783mm)
H: +04.00mm, V: +0755mm