Oce Arizona T220UV User Manual - Copies
Océ | Operating the Arizona T220UV
3-56
3010102780-B
- keys. When the digit you want is displayed, press ACCEPT and the underline moves
to the next digit. When you are at the last digit, press ACCEPT to choose the number of
overprints. The display advances to the Place Media menu.
Copies
Press + or - to change the number of copies printed. Options are 1 to 100. Use the
ACCEPT key to move through the displayed digits. The selected digit has an underline
indicating it can be increased or decreased using the + or - keys. When the digit you want
is displayed, press ACCEPT and the underline moves to the next digit. When you are at
the last digit, press ACCEPT to choose the number of copies that is displayed. The
display will advance to the Overprints display (if enabled).
Place Media Menu
The menu now displays the following pre-print message:
Press ACCEPT and the gantry will move to position itself over the media.
Printing does not start immediately as the UV lamps must warm up to printing
temperature so that they can cure the UV-based ink used for imaging on the media.
When printing begins, the image start point is the lower left corner of the image (Figure
Note:
If the grid is printed on the table, it will indicate the image origin point (See
Appendix A for details on printing the grid).
Print Mode
speed 1x
PRINT PARAMETERS
# Copies: 1
Print Mode
speed 1x
Place media on table. Turn vacuum ON.
Press ACCEPT to start printing