Oce Arizona T220UV User Manual - Clean Ozone Filters
Monthly Maintenance |
6/2/04
7-109
Clean Ozone Filters
Inspect and clean the eight ozone filters located on the gantry at least once a month, or
as needed. In environments where there is a lot of dust and debris in the air, you may
need to clean them more frequently.
Items Required:
•
Shop vacuum or hand-held vacuum
Procedure:
1.
Remove the square metal cover surrounding the ozone filter by retracting the two
clips and lifting it straight up and off.
2.
Carefully lift the filter from its bracket.
3.
Note that one side of the filter has a visible layer of dust. Vacuum this dust with a
handheld appliance.
Replacing Ozone Filters
Replace the ozone filters at least every two years. If your printer is used more frequently
than an eight hour shift per day, it might be necessary to replace them more often
Clean Gantry Door Fans
Inspect and clean the four fans located on each of the gantry doors at least once a month,
or as needed. In environments where there is a lot of dust and debris in the air, you may
need to clean them more frequently.
Items Required:
•
Shop vacuum or hand-held vacuum
Procedure:
1.
Open the gantry doors.
2.
Remove any visible dust on the surface or in the vents of the fan using a vacuum.
Note:
Make sure that you are in an environment that will remove any dislodged
dust particles from the air. Also make sure that you don’t expose the carriage
fan intake to the dust. Ideally, the filters can be cleaned in a room separate
from the printer or even outdoors.