Oce Arizona T220UV User Manual - page 93
Handling Media |
6/2/04
5-81
4.
Push the strips up against the long edges of the media, with the sharp edge protruding
into the middle part of the media edge. The strips will be held in place by the vacuum
holes underneath them
Figure 27 shows a sheet of 4'x8' Fome Cor on the printer table with a media holder strip
placed on one side of the media.
Figure 28 Sharp edge of the strip against the media.
In Figure 28 note that the sharp edge of the media holder strip butts up against the middle
of the edge of the media. This prevents warping and increases the effect of the vacuum.
•
The strips can be printed on if a bleed is required in the image. If the strips
are used for a bleed and the media thickness is more than 2mm greater than
the strips, overspray and nozzle dropout is likely to occur.
•
When not in use, the strips should be stored flat.
Warning: Do not print on mirrors or any other highly
reflective media as UV light is reflected off such media. This
results in curing the ink in the heads and thus damaging
them.