Oce Arizona T220UV User Manual - Fill Reservoir
Menu Structure |
6/2/04
2-35
FILL RESERVOIR
This command manually fills an ink reservoir with ink. This is generally only used
if ink-fill is turned Off and the user wants to manually ensure that the ink reservoirs
are full of ink. The system stops the filling when the ink reservoir level sensor
indicates that the ink reservoir is full.
MOVE GANTRY
Allows you to place the gantry at any location over the table in increments of 1 foot.
RAISE CARRIAGE
This command raises the carriage to currently-set media height then moves the
heads over the drain, which allows the carriage to be moved manually for service
access. Note that this allows the gantry doors to be opened without tripping the
interlock switches.
ACCESS CARRIAGE
This command raises the carriage to the currently-set media height and moves the
carriage over to the blotting station. This is useful to gain access to the underside
of the carriage in order to manually clean the print heads. Note that this allows the
gantry doors to be opened without tripping the interlock switches.
PARK CARRIAGE
This command moves the carriage to the home position in the capping station.
This ensure that the carriage is parked over the waste tray in case of any ink drips.
BLOT CLOTH DISPLAY
Allows you to determine when to start displaying the Blot Cloth Low message based
on the percentage of blot cloth remaining.
LAMP USAGE
Allows you to check both UV lamps for the total number of strikes and the length
of time the lamps were on so that you can monitor usage over time. It also allows
you to reset the usage statistics when you replace a lamp.
BARCODE PRACTICE
Allows you to practice scanning barcodes without using new bottles of ink so you
can get a feel for the barcode wand. Practice barcodes can also be entered manually