Oce Arizona T220UV User Manual - Daily Maintenance
Océ | Printer Maintenance
7-104
3010102780-B
7.2
Daily Maintenance
Clean ink from the table whenever necessary. Also check the waste bottle periodically
(although you will be notified by the control panel display when it is nearly full).
Removing Ink From the Table
Items Required:
•
Table Scraper (3012002368)
•
Poly-Wipe Cloth (0505-0283)
•
Butyl Gloves (3010101760)
Once the UV-curable ink is cured, the best method for removing it from the table is to
use the provided scraper (it is also possible to achieve good results with a razor blade
that is set into a handle/holder). Be careful not to scratch the aluminium surface of the
table when scraping off the ink.
Unplugging Vacuum Holes
The vacuum holes in the table surface may become plugged with ink and thus reduce the
efficiency of the vacuum. To clear the holes, use an 0.8mm diameter rigid material (e.g.,
a paper clip) to ream them out, as required (this is not likely a daily task, but must be
performed as needed).
Note:
When scraping ink off the table be sure to remove all of the dry ink particles.
Use a vacuum and a wet lint free cloth to ensure no debris is left on the table
that could be picked up by a print head.