Oce Arizona T220UV User Manual - Safety Information
Océ | Ink System Management
4-72
3010102780-B
4.1.1
Changing an Ink Bottle
The ink bottles are located on the Ink Station tray. Ink levels for each bottle are
monitored by sensors. Low ink levels are indicated on the control panel.
Figure 22 Ink Station showing Ink Bottles
Safety Information
Use appropriate safety equipment — butyl gloves and eye protectors. Take precautions
to avoid ink on your skin or in your eyes
When the control panel displays an “XXX ink low” message, that particular ink should
be replaced. Ink can be replaced at any time, with one exception — Do NOT replace inks
immediately after a purge since the ink pumps may be activated at that time. It is best to
replace an ink bottle when the printer is idle:
1.
Unscrew the lid on a new ink bottle and remove the silver sealing foil;
2.
Unscrew the lid on the empty ink bottle and unplug the coupler. Note that the lid
stays attached to the ink line and coupler. Put the old bottle aside and immediately
place the coupler into the new ink bottle by pushing the flange all the way into the
ink pick-up insert. Ensure that the coupler is fully inserted into the ink pick-up insert
to prevent air being drawn into the ink line when the pump is on.
Important: To reduce the chance of poor image quality, do not shake the ink supply
bottles before installation or during printing. This may introduce air
bubbles into the ink supply system.