Oce Arizona T220UV User Manual - 0.3.4
Océ | Installing Special Prints
-116-
3010102780-A
0.3.4
Printing the Grid File:
1.
Verify that only the Grid will be Printed: If the printer is currently configured to
print any additional information — e.g.,printer statistics or an away side prefire or
diagnostic stripe — disable these features so that only the grid will be printed on
the table.
2.
Select the Grid File from the Operator/Special Prints menu: The grid file print
file is pre-ripped and ready to print. Select your preferred version (metric or
imperial) of the Grid file.
3.
Zero the Thickness Setting: Make sure that you set the height to 0 (zero).
4.
Before Printing the Grid: be sure to use no offsets, and a media thickness of zero.
Don’t turn on the vacuum, as it is not required to print this job. The job will print
in four-pass mode.