Oce Arizona T220UV User Manual - Note:
Océ | Media
5-82
3010102780-B
5.1.4
Spoilboard Sheet Reduces Print Artifacts
When printing on thin, flexible, or porous media, the counter-bore holes in the vacuum
table of the T220UV can cause print artifacts (sometimes referred to as “dimpling”). If
you encounter this problem when printing, consider adding a spoilboard sheet between
the media and the table to reduce this problem.
North American contact information (a suggested source - other sources of similar
products may be available. Check your local hardware and router supply stores):
THERMWOOD Corp.
904 Buffaloville Road
PO Box 436
DALE, IN 47523
USA
Contact: Melanie Tullis
Tel.1-800-221-3865 Ext. 266
email: Melanie.Tullis@thermwood.com
You can get more information from their website:
http://www.woodworkerswholesale.com/
There are 2 spoilboard products from this manufacturer that we recommend for the
Arizona T220UV.
Part # TA00827 - 1/4"x5'x10' (Actual Size: 1/4" x 61" x 121")
Part # TA00826 - 1/4"x4'x8' (Actual Size: 1/4" x 49" x 97")
Tips for Using the Underlay Sheet:
•
Use scrap pieces of media to cover any exposed area of the underlay sheet
that the carriage will travel over. This prevents the spoilboard sheet from
lifting off the table and colliding with the carriage.
•
It may be necessary to bleed the vacuum by opening, or partially opening
an additional vacuum zone to reduce dimple artifacts.
•
confirm that the spoilboard (underlay) thickness is set correctly.
•
select UL when printing a job using the spoilboard.
Note:
If you think that you need this product, you must buy directly from the
manufacturer. We recommend that you buy more than one sheet due to the
shipping costs.