Oce Arizona T220UV User Manual - Note:
Menu Structure |
6/2/04
2-37
9. Press ACCEPT. You then see:
TEST PRINT NOZZLE PRINT
media width: xxx.x cm
10. Press ACCEPT. You then see:
NOZZLE PRINT
Thickness: 0.00m (noUL), UV: xx%
Use the +/- buttons if you want to change the thickness or UV lamp
setting. Refer to section “Changing Print Job Settings” on page 53 for
details on changing these settings.
The printer begins printing the selected Nozzle Print (either standard or
diagnostic). The control panel displays the on-line statistics.
Figure 4 Diagnostic Nozzle Print
Note:
The “noUL” refers to whether an UnderLay spoilboard is used below
the media to prevent dimpling. If an underlay is present, the display
will show “UL” and compensate for its thickness. For more
information, see “Spoilboard Sheet Reduces Print Artifacts” on
Note:
The label for each color is not actually incuded in the nozzle print. The labels
are here for illustration purposes only. Also in a nozzle print, the pattern
shown here is repeated both horizontally and vertically.