Oce Arizona T220UV User Manual - Monthly Maintenance
Océ | Printer Maintenance
7-108
3010102780-B
7.4
Monthly Maintenance
Clean Gantry Rails
Dust and debris can accumulate on the gantry rails that run along the length of the table.
The bearings that run on the rails are equipped with shields that are designed to keep
debris from entering the bearing housing. After a period of time, debris can accumulate
on the outside of the bearing shields as the gantry traverses the table.
Items Required:
•
Poly-Wipe lint-free Cloth
Safety Information
Use appropriate safety equipment — butyl gloves and eye protectors.
Procedure:
1.
Power OFF the T220UV at the AC power On/Off switch located at the side of the
electronics enclosure.
2.
Use a dry lint-free cloth to remove all visible debris that has accumulated next to
the bearing shields. It is only necessary to clean the outside bearing shields. When
removing debris always wipe away from the shields.
3.
Power ON the T220UV.
Important: In the event of an ink spill on the rail, it should be cleaned immediately,
before the bearings have a chance to run over the spill. After the area
has been cleaned, wipe the spill area again thoroughly with a water-
moistened lint-free cloth to remove any chemical residue before
running the gantry over the area again. Slight ink stains that remain on
the rail after cleaning are not a major problem.