Qlogic 3200 Series User Manual - page 104
5–Fibre Channel Noninteractive Commands
-t (Display Target Information)
5-34
SN0054667-00 B
This feature is supported with 8Gb mezzanine and blade adapters. It is not
needed with the standard QLE2562 adapters.
-t
(Display Target Information)
To show the target information for all adapters in the system, issue the following
command:
# qaucli -pr fc -t [
To show the target information for a specific adapter, issue the following
command:
# qaucli -pr fc -t (<hba instance> | <hba wwpn>)
To show specific target information for a specific target on an adapter, issue the
following command:
# qaucli -pr fc -t (<hba instance> | <hba wwpn>) (<target wwpn> |
<target port id>)
Where:
To show the target information on all adapters, issue the following command:
-t [<all>]
To show the target information on a specific adapter, issue the following
command:
-t (<hba instance> | <hba wwpn>)
To show the target information for a specific target on a specific adapter, issue the
following command:
-t (<hba instance> | <hba wwpn>) (<target wwpn> | <target port id>)
iiDMA (intelligent interleaved direct memory access) settings include:
—targets | –t
applies to all targets.
indicates the supported intelligent interleave factor: 1, 2, 4, or
8Gbps.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
target wwpn = World wide port name of the target
target port id = Port ID of the target