Qlogic 3200 Series User Manual - page 98
5–Fibre Channel Noninteractive Commands
-o (Output to a File)
5-28
SN0054667-00 B
-o
(Output to a File)
To output result and status messages into a file, type -o, followed by the file
name. For example, to save LUN information to a file named systemLUNinfo:
# qaucli -pr fc -l -o systemLUNinfo
Where the file name is systemLUNinfo, all messages are located in the
directory indicated for the system platform:
-p
(Display Persistent Target Binding Info)
With this command you can:
Show binding information for one or on all adapters.
Bind a specific target to a selected adapter.
Bind all targets on a specific adapter or on all adapter.
Unbind a specific target.
Unbind all targets on a specific adapter or on all adapters.
e
Operation mode (QLA/QLE23xx, QLA/QLE24xx, and QLE2562):
0 = interrupt for every I/O completion
5 = interrupt when interrupt delay timer expires
6 = interrupt when interrupt delay timer expires or no active I/O
NOTE:
QLA200/210 adapters have a limited set of parameters that can be
changed.
NOTE:
The -o option is valid only in noninteractive mode.
This option can be used with all noninteractive mode options that have a
corresponding interactive mode option (see
Table 5-1
). The option must
be the first or last command in the command line.
If the file already exists, new data are appended to the current file.
Windows:
syslog.log
in the current directory
Linux:
/var/log/messages
Mac OS:
/var/log/system.log