Qlogic 3200 Series User Manual - -X2
5–Fibre Channel Noninteractive Commands
-x (Output in XML Format 1)
SN0054667-00 B
5-37
To create a virtual port with a specific WWPN, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) create
hex>
When prompted, enter two hexadecimal digits. The system checks these digits to
be sure they are unique and, if they are, puts them into byte 1 of the WWPN.
To delete all virtual ports on a physical adapter port, issue the following command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) delete all
To delete a specific virtual port on a physical adapter port, issue the following
command:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) delete <vport
wwpn>
-x
(Output in XML Format 1)
You can use this option with all noninteractive mode options that have a
corresponding interactive mode option (see
Table 5-1
). This option must be the
first or last command in the command line.
When you use this option, the system shows all result and status messages in
XML format 1, a legacy format. This option is usually combined with the -o option
(see
“-o (Output to a File)” on page 5-28
) to create a text file with XML output so
that it can be parsed by an XML-compliant utility. For example to show adapter
general information and output it to an XML file named output.xml:
# qaucli -pr fc -i all -x -o output.xml
-x2
(Output in XML Format 2)
You can use this option with all noninteractive mode options that have a
corresponding interactive mode option (see
Table 5-1
). This option must be the
first or last command in the command line.
When you use this option, the system shows all result and status messages in
XML format 2, standard XML format. This option is usually combined with the -o
NOTE:
This option is valid only in noninteractive mode.
NOTE:
This option is valid only in noninteractive mode.