Qlogic 3200 Series User Manual - page 2
ii
SN0054667-00 B
User’s Guide QConvergeConsole CLI
2400, 2500, 3200, 8100, 8200 Series Adapters
Information furnished in this manual is believed to be accurate and reliable. However, QLogic Corporation assumes no
responsibility for its use, nor for any infringements of patents or other rights of third parties which may result from its
use. QLogic Corporation reserves the right to change product specifications at any time without notice. Applications
described in this document for any of these products are for illustrative purposes only. QLogic Corporation makes no
representation nor warranty that such applications are suitable for the specified use without further testing or
modification. QLogic Corporation assumes no responsibility for any errors that may appear in this document.
Document Revision History
Revision A, December 13, 2010
Revision B, March 31, 2011
Changes
Sections Affected
Added a brief description of the currently undocu-
mented interactive command mode.
“Preface” on page xxi
Updated the QLogic technical support information.
“Technical Support” on page xxiv
Removed the requirement for TCP/IP protocol for
Windows remote management.
“Software Requirements” on page 1-2
Corrected the Windows CLI uninstallation proce-
dure from the Start menu.
“Start Menu Uninstall” on page 2-5
Corrected the Linux CLI uninstallation procedure.
“Uninstalling QConvergeConsole CLI in a Linux
Environment” on page 2-6
Removed the following invalid NIC help com-
mands:
> qaucli -pr nic -?
> qaucli -pr nic ?
“-h (Help)” on page 4-5
Added a note defining teaming as a Windows-spe-
cific feature.
“-teamdel (Delete Team)” on page 4-16
Added a note defining VLANs as a Windows-spe-
cific feature.
“-vlanadd (Add VLAN to Port or Team)” on
page 4-21
Added note that the option to save the FCode to a
file type is not supported for QLE8242.
“-b (Save or Update the Flash BIOS or FCode)” on
page 5-6
Changed data rate and operation mode table note
references from 8Gb Adapter to QLE2562 in the
Fibre Channel Noninteractive Commands chapter.
Table 5-9
Changed the references from 8Gb Adapter to
QLE2562. in specific commands in the Fibre
Channel Noninteractive Commands chapter.
“-u (Firmware Area Update/Save)” on page 5-35
“-sp (Update Adapter Firmware)” on page 5-33
Added sections 7-NIC Interactive Commands,
8-Fibre Channel Interactive Commands, 9-Con-
verged Network Adapter Commands
Section 7
,
Section 8
,
Section 9