Qlogic 3200 Series User Manual - -Edchap
6–iSCSI Noninteractive Commands
-edchap (Edit a CHAP Entry)
6-10
SN0054667-00 B
-edchap
(Edit a CHAP Entry)
To change the value of the specified CHAP entry, issue the -edchap command
as follows:
-edchap <hba_port_inst>
<Value> [<Parameter> | <Parameter Alias> <Value> …]
You can repeat the <Parameter>|<Parameter Alias> <Value> parameter
pair to change multiple values as shown in
Table 6-2
. Press ENTER after each
entry.
Issuing this command resets the adapter.
-ei
To get information about errors and exit codes for noninteractive mode, issue the
-ei
command as follows (no parameters are required):
-ei
-f
(Update Firmware Image—Specific HBA)
The firmware runs the tasks involved in data management, the iSCSI protocol,
and general adapter functioning. Use the -f command to update the firmware
image.
To update the adapter firmware from a specified file, issue the -f command as
follows:
-f <hba_port_inst> <file name>
Both parameters are required. The <hba_port_inst
>
is the adapter to update.
The <file name> is the file containing the firmware image to upload to the
adapter. Be sure to use full path names. Issuing this command resets the adapter.
Table 6-2. CHAP Parameters
Parameter
Parameter Alias
Value
CHAPName
CNAME
character string
CHAPSecret
CSECRET
character string
CHAPBidi
CBIDI
on or off