Qlogic 3200 Series User Manual - -Pbootcode
Manual is about: QConvergeConsole CLI
of
300
6–iSCSI Noninteractive Commands
-pbootcode (Set Primary Boot Target Information)
SN0054667-00 B
6-21
-pbootcode
(Set Primary Boot Target Information)
To set the primary boot-code boot target and LUN, issue the -pbootcode
command as follows:
-pbootcode <hba_port_inst> <tgt> <lun>
This command is not active for the PPC.
For information on secondary boot code, see
“-sbootcode (Set Secondary Boot
Target Information)” on page 6-25
.
-pdt
To disable a target, issue the -pdt command as follows:
-pdt <hba_port_inst> <targetId>
-pet
To enable a target, issue the -pet command as follows:
-pet <hba_port_inst> <targetId>
-pinfo
(Port Information)
To view port information for the specified adapter, issue the -pinfo command as
follows:
-pinfo <hba_port_inst>