Qlogic 3200 Series User Manual - page 206
9–Converged Network Adapter Interactive Commands
CNA FCoE Configuration
9-20
SN0054667-00 B
the value. Refer to
Table 5-9
for details about these parameters and their values.
For example:
1: Connection Options
2: Data Rate
3: Frame Size
4: Hard Loop ID
5: Loop Reset Delay (seconds)
6: Enable BIOS
7: Enable HBA Hard Loop ID
8: Enable Fibre Channel Tape Support
9: Operation Mode
10: Interrupt Delay Timer (100ms)
11: Execution Throttle
12: Login Retry Count
13: Port Down Retry Count
14: Enable LIP Full Login
15: Link Down Timeout (seconds)
16: Enable Target Reset
17: LUNs per Target
18: Enable Receive Out Of Order Frame
19: Commit Changes
20: Abort Changes
Restore Defaults
From the HBA Parameters menu, select the Restore Defaults to restore adapter
parameters to their factory default values.
For example:
Warning:
Please update the HBA parameters with extreme care.
Incorrectly updating the HBA parameters may render the HBA inoperable.
If you currently have boot device information set up in the HBA
parameters, updating the HBA Parameters from a file
will preserve that information.
Do you want to proceed with the operation?
1: Yes
2: No
CAUTION!
Restoring the adapter parameters can make the adapter inoperable.
When restoring NVRAM parameters, the current BIOS device settings
are also cleared.