Qlogic 3200 Series User Manual - page 80
5–Fibre Channel Noninteractive Commands
-e (Boot Device View | Select | Disable)
5-10
SN0054667-00 B
To view the current boot device selection on all adapters:
# qaucli -pr fc -e (view | info)
To view the current boot device selection for a specific adapter:
# qaucli -pr fc -e (<hba instance> | <hba wwpn>) (view | info)
In Windows and Linux, each adapter’s currently selected boot device is shown in
the following format:
<hba instance> <hba wwpn> <target wwnn> <target wwpn> <lun id>
If the system does not have an adapter with a boot device selected, the following
message appears:
There is no boot device selected for any HBA in the system.
Following is an example of the boot device option when viewing the boot device
for a single adapter. In this example, no boot device is configured (selectable boot
is disabled; the boot port name is all zeroes).
-------------------------------------------------------------
HBA 1: QLA2340 WWPN xx-xx-xx-xx-xx-xx-xx-xx Port ID 00-00-00
-------------------------------------------------------------
Boot Device Settings:
--------------------------------------
Selectable Boot: Disabled
--------------------------------------
(Primary) Boot Port Name
LUN
----------------------- -----------------------
------
00-00-00-00-00-00-00-00
00-00-00-00-00-00-00-00 0
Press
To cause the OS to boot from the first target it finds with a LUN, select a boot port
name of 00-00-…00 (selectable boot); this applies only if the boot BIOS is
enabled.
To set a specific target as the boot device for a specific adapter, issue the
following command:
# qaucli -pr fc -e (<hba instance> | <hba wwpn>) <target wwnn>
<target wwpn> <target id> <lun id>
NOTE:
The boot device setting option is not supported on Macintosh
®
PowerPC.