Oki ES4192dn User Manual - page 104
About Remote Scan
You can scan an image from a computer connected via a network or USB interface. Operate the computer to start to scan a document.
To use the Remote Scan function, you must set the following settings and install software.
Connecting This Machine to a Network
Connecting a Computer to This Machine via a USB Interface
Installing a Driver and Software to a Computer
Memo
The required software varies depending on the OS of your computer and the function to use. Install the appropriate software.
When using Remote Scan, start the TWAIN driver from utility that is installed in a computer (such as ActKey, PaperPort, etc.) to scan.
Note
Connect the machine to a computer via a network or USB interface.
To connect the machine to a network, set the following.
Set [TCP/IP] to [Enable].
Match the IP version between the machine and a computer.
Set the DNS server.
Enable the network TWAIN setting.
In Secure Scan mode, the administrator must register information about a computer from which Secure Scan is performed from
the operator panel or the Web page in advance.
For Mac OS X, when you perform a network scan for the first time after installing the scanner driver, the connection destination
selection tool of this machine starts, and set this machine as the connection destination.
When operating the machine via the WSD Scan connection, set the followings.
Set [TCP/IP] to [Enable].
Match the IP version between the machine and a computer.
Enable the WSD Scan function.
Install the machine on the computer.
103