Oki ES4192dn User Manual - page 811
of
1228
Adjusting the Density When Faxing
This section describes how to change the default setting of the density when faxing. You can adjust the density in seven levels.
1.
Press [Device Settings] on the touch panel.
2.
Press [Admin Setup].
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Press [OK].
5.
Press [Fax Setup].
6.
Press [Default Settings].
7.
Press [Density].
8.
Select a value.
9.
Press [Back] until the home screen is displayed.
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or
[-3] (lightest).
810