Oki ES4192dn User Manual - page 360
Erasing Edge Shadows When Sending (Edge Erase)
A black shadow may be scanned around the edges of the scanned document. The edge erase function allows you to erase the black
shadow.
Memo
[Edge Erase] is set to [OFF] by factory default.
The default value of the edge width to erase can be changed from [Admin Setup] > [Fax Setup] > [Default Settings] > [Edge
Erase] > [ON] > [Width].
1.
Press [Fax/Internet Fax] or the
(FAX) button.
The touch panel display switches to the fax/Internet fax top screen.
Memo
To display the home screen, press the
(HOME) button.
2.
Set a document in the ADF or on the document glass.
3.
Press [Fax].
4.
Press [Edge Erase] on the [Advanced] tab.
5.
Enter a value from 2 to 50 mm (0.1 to 2.0 inches) in [Width] by using the 10-key pad or pressing
on the touch panel, and then press [OK].
Memo
If you press [Cancel], the screen returns to the previous screen without saving the changes.
6.
Specify a destination.
Specify a destination in one of the following ways.
Selecting from the Transmission History and Reception History
7.
Change other settings if necessary, and then press the
(START) button.
Transmission starts.
359