Oki ES4192dn User Manual - page 809
of
1228
Adjusting the Density When Scanning
This section describes how to change the default setting of the density when scanning. You can adjust the density in seven levels.
1.
Press [Device Settings] on the touch panel.
2.
Press [Admin Setup].
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Press [OK].
5.
Press [Scanner Setup].
6.
Press [Default Settings].
7.
Press [Image Settings].
8.
Press [Density].
9.
Select a value.
10.
Press [Back] until the home screen is displayed.
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or
[-3] (lightest).
808