Oki ES4192dn User Manual - page 1169
7.
Click [OK].
8.
Select [OK] in the [Key Exchange Security Methods] window.
9.
Click [OK] in the [Key Exchange Settings] window.
Setting an IP Filter
1.
Select the [Rules] tab in the IP security policy properties window.
2.
Click [Add].
3.
Click [Next] in [Security Rule Wizard].
4.
Select [This rule does not specify a tunnel] on the [Tunnel Endpoint] screen, and then click [Next].
5.
Select [All Network Connections] on the [Network Type] screen, and then click [Next].
6.
Click [Add] on the [IP Filter List] screen.
7.
Click [Add] in the [IP Filter List] window.
8.
Click [Next] on [IP Filter Wizard].
9.
Click [Next] on the [IP Filter Description and Mirrored property] screen.
10.
Click [Next] on the [IP Traffic Source] screen.
11.
Click [Next] on the [IP Traffic Destination] screen.
12.
Click [Next] on the [IP Protocol Type] screen.
13.
Click [Finish].
Setting Filter Actions
1.
Click [OK] in the [IP Filter List] window.
2.
Select a new IP filter from the list on the [Security Rule Wizard], and then click [Next].
3.
Click [Add] on the [Filter Action] screen.
4.
Click [Next] in the [Filter Action Wizard].
5.
Enter [Name] and [Description] on the [Filter Action Name] screen.
6.
Select [Negotiate security] on the [Filter Action General Options] screen, and then click [Next].
7.
Select [Do not allow unsecured communication] on the [Communicating with computers that do not
support IPsec] screen, and then click [Next].
8.
Select [Custom] on the [IP Traffic Security] screen, and then click [Settings].
9.
Set in the [Custom Security Method Settings] window, and then click [OK].
Note
Select the same value specified in [IKE Encryption Algorithm], [IKE Hush Algorithm], and [Diffie-Hellman group] in the "Phase1
Proposal" setting in "
10.
Click [Next] on the [IP Traffic Security] screen.
11.
Select the [Edit Properties] check box, and then click [Finish].
1168