Oki ES4192dn User Manual - page 675
Network Menu
Set the basic settings and other network settings.
1.
Press [Device Settings] on the touch panel.
2.
Press [Admin Setup].
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Press [OK].
5.
Press [Network Menu].
6.
Select an item, and then change the setting.
Press [OK] by following the on-screen instructions if necessary.
7.
Press [Back] until the home screen is displayed.
Item
Factory default
setting
Description
Network
Setup
Network
Setting
TCP/IP
Enable
Sets whether to enable TCP/IP.
NetBIOS over TCP
Enable
Sets whether to enable NetBIOS over TCP/IP.
Display condition: TCP/IP protocol is enabled.
IP Address Set
Auto
Sets the method of assigning an IP address.
IPv4 Address
192.168.100.100 Sets an IP address.
Display condition: TCP/IP protocol is enabled.
Subnet Mask
255.255.255.0
Sets a subnet mask.
Display condition: TCP/IP protocol is enabled.
Gateway Address
0.0.0.0
Sets a gateway address.
Display condition: TCP/IP protocol is enabled.
DNS Server (Primary)
0.0.0.0
Sets the IP address for a Primary DNS server.
Display condition: TCP/IP protocol is enabled.
DNS Server (Secondary)
0.0.0.0
Sets the IP address for a Secondary DNS server.
Display condition: TCP/IP protocol is enabled.
WINS Server (Primary)
0.0.0.0
Sets the name or the IP address for the WINS server.
Display condition: TCP/IP protocol is enabled.
WINS Server (Secondary)
0.0.0.0
Sets the name or the IP address for the WINS server.
Display condition: TCP/IP protocol is enabled.
Proxy
Disable
Sets whether to use proxy.
Proxy Server
(NULL)
Sets the name or IP address of the proxy server. You can
enter up to 15 characters.
Proxy Server Port No.
8080
Sets the port number of the proxy server.
Proxy User ID
(NULL)
Sets the user ID to connect to the proxy server.
Proxy Password
(NULL)
Sets the password to connect to the proxy server.
Web
Enable
Sets whether to enable access from a Web browser.
Display condition: TCP/IP protocol is enabled.
Telnet
Disable
Sets whether to enable access from the Telnet.
Display condition: TCP/IP protocol is enabled.
FTP
Disable
Sets whether to enable access with FTP.
Display condition: TCP/IP protocol is enabled.
IPSec
Disable
This item is displayed only if IPSec is set to valid. This
item can be changed to disable only.
SNMP
Enable
Sets whether to enable access from SNMP.
674