Oki ES4192dn User Manual - page 672
Jam Recovery
Enable
Sets whether to print the pages again that are not printed due to a
paper jam after the jam is cleared.
Paper Black
Setting
0
Corrects the unevenness of printed characters caused by temperature
differences.
Change the value if the characters are faded.
Darkness
0
Sets print darkness.
SMR Setting
0
Corrects variations in print results caused by temperature and humidity
conditions and differences in print density and frequency. Change the
setting if the print quality is uneven.
BG Setting
0
Corrects variations in print results caused by temperature and humidity
conditions and differences in print density and frequency. Change the
setting if the background is dark.
Position
Adjust
Tray 1
X
Adjust
0 mm
X Adjust: Adjusts the position of the entire printing image
perpendicular to the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Y Adjust: Adjusts the position of the entire printing image parallel to
the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Duplex X Adjust: Adjusts the position of the image on the back side of
a duplex print perpendicular to the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Duplex Y Adjust: Adjusts the position of the image on the back side of
a duplex print parallel to the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Y
Adjust
0 mm
Duplex
X
Adjust
0 mm
Duplex
Y
Adjust
0 mm
Tray 2
(Optional)
X
Adjust
0 mm
Y
Adjust
0 mm
Duplex
X
Adjust
0 mm
Duplex
Y
Adjust
0 mm
MP Tray
X
Adjust
0 mm
Y
Adjust
0 mm
Duplex
X
Adjust
0 mm
Duplex
Y
Adjust
0 mm
Drum Cleaning
OFF
Sets whether to clean the drum before printing. The image quality
improvement may be expected.
Hex Dump
OFF
Prints out the data received from the host computer in hex. To finish
printing, turn the machine off.
System
Configuration
Menu
Personality
Auto
Selects the emulation mode. If auto is set, the correct emulation is
automatically selected every time a print job is received.
Alarm Release
Manual
If [Manual] is set, non-critical warnings, such as requests for a different
paper size, can be cleared by pressing [RESET]. If [Auto] is set, the
warnings are cleared when the print job resumes.
Auto Continue
OFF
Sets whether the machine automatically recovers from a memory
overflow.
Error Report
OFF
Sets whether to print error details if PostScript errors occur.
PCL Setup
Font Source
Resident
Selects the location of the font to use.
Font No.
I0
Selects the font number to use.
Available range: I0 to I90 if [Resident] is set/C1 to C4 if [Resident 2] is
set
Font Pitch
10.00 CPI
Sets the width of the PCL default font.
Available range: 0.44 to 99.99 CPI (0.01CPI increments).
Font Height
12.00 point(s)
Sets the height of the PCL default font.
671