QMS 2060 User Manual - page 148
Manual is about: Print System
of
258
Single In-Line
Memory Modules
(SIMMs)
QMS 2060 WX Print System User
’
s Guide
5-18
10 Lift the controller board and position it on the guide rails
inside the printer.
11 Slide the controller board in until it’s firmly seated in the
printer.
12 Tighten the two screws you loosened earlier.
Push in each screw and then tighten.
13 Reconnect the interface cable(s) and the power cord, and
then turn on the printer.
The amount of memory installed and the system software version
are displayed in the control panel message window as the printer
starts up.
Guide
Rails