QMS 2060 User Manual - page 158
Introduction
QMS 2060 WX Print System User's Guide
6-2
Introduction
This chapter describes how to handle and clean the printer as well as
how to replace a toner cartridge.
Blurred or splotchy prints and paper jams can result from dusty printer
parts. Regular cleaning takes only a few minutes and helps ensure
print quality. Printer parts that require cleaning are the paper pick-up
rollers and the outside surface of the printer.
Handling the Printer
Handle the printer with care to preserve its life. Abuse may cause
damage. Keep the following guidelines in mind:
n
Don’t place anything on the top of the printer.
n
Don’t place anything on the multipurpose tray except the media
being used for printing.
n
Avoid spraying cleaning solution directly on the printer’s surface;
the spray could penetrate through the air vents of the printer and
damage the internal circuits.
n
Be careful when cleaning the inside or removing paper jams, as
the fixing assembly and other internal parts become very hot.
Leave the printer cover open before handling the inside of the
printer.
n
Don’t close the covers abruptly or expose the printer to vibrations.
n
Don’t cover the printer immediately after using it. Turn it off, and
wait until it cools down.
n
Don’t leave the printer open for any length of time, especially in
well-lit places; light may damage the toner cartridge.
n
Don’t open the printer during printing and do not tap paper stacks
on the printer.
n
Don’t tilt, lubricate, or disassemble the printer.