QMS 2060 User Manual - page 97
Printing on
Different Types
of Media
3-13
Printing
3
Use the Windows printer driver to select manual feed, trans-
parency printing, and any other printing options you want.
4
Send the print job.
Labels
Your printer supports label printing from the multipurpose tray (up to
10 sheets). Adhesive label stock has pressure-sensitive (peel and
stick) adhesive backing. A label consists of a face sheet, the adhe-
sive, and the carrier sheet.
Special Considerations
n
Use label stock with pressure-sensitive (peel-and-stick) adhesive
backing. Avoid using label stock with exposed adhesive; it may
stick to the toner cartridge or the fixing roller, causing labels to
peel off and printer jams to occur.
n
The label printing surface must cover the entire carrier sheet, and
no adhesive should come through on the surface. The adhesive
and carrier sheet must withstand the fusing temperature (200
°
C/
392
°
F).
n
The face sheet printing surface must adhere to the plain paper
specifications listed in appendix B, “Technical Specifications.” We
recommend Avery 5160, letter or A4 size.
n
Label data should be formatted within your application. Try print-
ing your data on a plain sheet of media first to check placement.
This reduces the number of label sheets you use.
n
Before printing labels, disable the duplexer if it’s installed and
check the manual feed guides to make sure they’re not too tight
and buckling the labels.
n
Load the labels long edge first, face up, and with the top of the
page toward the rear of the printer.
Printing
1
Format the labels in your application.