QMS 2060 User Manual - Xxxxxxxx Xxx
Printer Status
Messages
QMS 2060 WX Print System User's Guide
8-4
Ethernet error
xx
An Ethernet error has occurred. Record
the error number and contact your
system administrator or the QMS
Response Center.
101 Hardware address conflict
103 mem err
104 appinit
]105 net err
106 net err
107 event err
108 event err
109 hardware address conflict
110 err
111 err
112 couldn’t program physical
113 err
114 RARP err
115 couldn’t program logical address
124 snetopen err
125 netxopn err
126 makeport full
241 shift err
242 fifo count error
Ethernet port
The printer has identified an Ethernet
interface connection during startup.
F#
xxxxxxxx xxx
i960 fault
There is a processor fault. Call for
service (see “Placing a Service Call” on
page 8-41).
Flash error
There is a flash ROM problem. Call for
service (see “Placing a Service Call” on
page 8-41).
HW err 0 cancel
The Ethernet hardware address is not
set. Use the Eth. HW address menu to
set it (see chapter 4, “Control Panel).
This message...
indicates...
» Note:
Shaded table cells indicate that the message scrolls.