NEC WL1700-MS Installation Manual - page 112

Data Assignment

Chapter 4

INITIAL SETUP

78

About CLI

The two types of the command mode exist in WL Controllers: Network Access 

Mode and Administrative Access Mode. When you log in to a Controller, you 

automatically enter Network Access Mode. To configure the Controller settings, 

type 

enable

 to enter Administrative Access Mode. 

As a default prompt, “WL + the last six digits of MAC address” is shown.

Explanation of each mode is as follows:

Note.  

When the UNIVERGE WL Controller is in factory default state or after CLI 

prompt changing, "*" appears at the head of the prompt until the prompt setting is 

saved.

Table 2. CLI Command

Mode

Prompt

Explanation

Network Access Mode

>

A part of Config File can be displayed 

by using show commands.

Administrative Access 

Mode

#

Config file can be edited/deleted/

displayed by various commands.