NEC WL1700-MS Installation Manual - Cable Connection

Cable Connection

Chapter 3

INSTALLATION

48

Cable Connection

This section explains how to connect PC/Network Equipment with WL 

Controller.

The following is an example using SCA-WL10.

Note.  

WL Controller is activated with the default IP address “192.168.100.10/24”. The 

following will be usually proceeded to set a WL Controller with initial setting.

1. Connect a PC with a WL Controller directly.

2. Modify an IP address.

For more information, refer to 

“Connecting PC with WL Controller” on page 53

.

10BASE-T/100BASE-TX

 (Straight cable)

Network Equipment (such as SW HUB)

Maintenance Console:

  This is used to configure WL Controllers 

  and WL Access Points.

Connect to Ether1 Connector

Ether1

100M   LINK

100M   LINK

Ether2

PWR

ACT

ALM

LOAD

Front View

10BASE-T/100BASE-TX

 (Cross-over cable)

Connect to an inlet 

Stopper 

(To fix AC power cable)

PACT

Rear View