NEC WL1700-MS Installation Manual - page 150
Data Assignment
Chapter 4
INITIAL SETUP
116
Performing the following steps with
marks (minimum settings) can
create a WL network. The following is a network configuration when you perform
the basic settings.
Note.
To create the above network, DHCP Server is required to distribute IP
addresses to WL Access Points. If you use Simple DHCP Server function installed in
Controller, refer to
in CLI.
For more information about examples of network configurations, refer to the
Basic Settings
AP2
AP1
Layer 2 Switch (PoE)
Default Gateway
䇭
IP Address
䋺
192.168.10.25
䇭
Subnet Mask
䋺
255.255.255.0
RADIUS Server
䇭
IP Address
䋺
192.168.10.100
DHCP Server
ROUTER xxxx
Ch=11
Tx=10
Ch=36
Tx=10
Ch: Channel
Tx: AP Transmission Power
RF: Radio Frequency
ESSID
䋺
Identifier in wireless networks
Ch=6
Tx=10
RF1(802.11b/g)
RF1(802.11b)
RF2(802.11a)
Serial ID=123456789
Serial ID=987654321
ESSID=B1(802.11x)
ESSID=B1(802.1X)
ESSID=B2(WPA)
ESSID=A1(WPA)
HTTPS
Maintenance Console
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD