NEC WL1700-MS Installation Manual - page 202
Configuration Management
Chapter 6
SYSTEM MAINTENANCE
168
Backup
While you are configuring data, the data is being written into running-config data
on memory.
Data in the running-config will be lost if the system restarts or is powered off. To
retain the configuration after those events, save the data into a Flash Card or TFTP
Server.
Note.
Use the following commands to show contents in running-config.
Using CLI
Use
show configuration
.
*Adding an optional parameter “
all
” after the command, default settings
will be displayed in the command response.
Using WebView
Always reflect running-config on the display.
Backup into Flash Card
Use the following to copy running configuration into Flash Card.
Using CLI
Use
save configuration [file name]
.
If a file name is omitted in the command, the configuration will be saved
as the boot configuration file used at the current system.
Using WebView
Click the
Save Configuration
button, which is located on the top right of
the screen. The configuration will be saved as the boot configuration file
used at the current system.
To display the configuration file used at the current system, use the following:
Using CLI
Use
show boot
.
In the lists, the file name is indicated after Booted Configuration on the
screen.