NEC WL1700-MS Installation Manual - page 139
Manual is about: UNIVERGE WL Series Wireless Controller
of
226
Data Assignment
Chapter 4
INITIAL SETUP
105
44
Check to see if the Controller is operating normally in your network.
Check to see the normal condition of the Controller by using
ping
or
tracert
command. Besides, use
telnet
command to log in to the Controller and use
show
command to check the parameters assigned. For more information on
those commands, refer to
“Check Configurations/Network Status” on
When WL1700-MS is used, after confirming that the Controller is in normal
state, attach the WL Intelligence Access Point to an appropriate location. For
more information, refer to
“Access Point Installation” on page 58
.
Basic Settings