NEC WL1700-MS Installation Manual - page 192
Data Assignment
Chapter 4
INITIAL SETUP
158
4
Configure Access Points
Table 8. Configure Access Points - AutoRF is enabled in this case
PARAMETERS
REMARKS
Internal
AP
Serial Number
(printed on the bottom)
Input the serial number (indicated as
“S/N”) printed on the bottom of WL
Intelligent Access Point [10
alphanumeric characters].
Model
Select a model to be used.
In the case of using APs in Japan,
select
WL1700-MS(AP)-JP
.
In the case of other than Japan, select
WL1700-MS(AP)
.
External AP1 to AP3
Select this box and specify the
following:
Serial Number
(printed on the bottom)
Input the serial number (indicated as
“S/N”) printed on the bottom of the
WL Access Point [10 alphanumeric
characters].
Model
Select a model to be used.
In the case of using APs in Japan,
select
WL1500-AP-JP
. In the case of
other than Japan, select
WL1500-AP
.