NEC WL1700-MS Installation Manual - page 178
Manual is about: UNIVERGE WL Series Wireless Controller
of
226
Data Assignment
Chapter 4
INITIAL SETUP
144
21
After restart has been completed, connect the Controller to your network
(LAN/WAN).
The following is an example when PC is connected to SCA-WL10. In the case
of WL5100, WL5100 is also connected through Ether 1 connector.
10BASE-T/100BASE-TX
Network Equipment (SW HUB,etc)
Maintenance Console
Connect the LAN cable to Ether1 Connector.
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Front
LAN/WAN